.

Tuesday, January 21, 2014

Mapping a Galaxy

Below is the basic procedure followed while on the bowed stringed instrument reactor at the Kitt Peak National Observatory 0.9m WIYN telescope. in that location are numerous checklists and procedures built into the observing process to in certain the apropos retrieval of useful data as well as safety of the observers and equipment. Upon entering the attic the S2KB camera status was checked using the ccdstat sway in the ascendance language, Image drop-off and Analysis Facility (IRAF), which learnled the CCD resource run to be sure that it was operating at a temperature of -109C and that solely other systems were process normally. The Dewar, attached to the camera, was filled with liquid north all 12 hours in order to maintain the sublime temperature of -109°C. From the Dewar a pig ribbon ran to the CCD imagery chip, acting as a inflame sink. A mapping check of the CCD visualise chips temperature was made every 6 hours, by using the IRAF command ccdst at. After the r bulge outine check of the CCD visualise chip was made, warpes and flats were interpreted by imaging the white rectangle on the inside of the edible bean. The dome was opened and gradatory to the position of the telescope. IRAF was used to control the imaging process and a separate computer control add-in was used dear stop and guide the telescope and control the dome. Images were taken in a precise order for one hundred eighty second integrations. The images were saved to the KPNO network. The dome was then closed and CCD imaging chip refilled with liquid nitrogen. Reviewed images and denominate them according to the order in which they were taken. Discarded all images that were of woeful quality. Selected valid flats and biases. Averaged the flats and biases to produce a master bias and flat. Subtracted the bias and divided the flat out of each image. Inverted the images vertically. sedulous the use of Visual locate in order to astro metrically garnish the images and to embed ! World consecrate System data into the FITS header. utilise data found in...If you insufficiency to get a full essay, order it on our website: OrderEssay.net

If you want to get a full information about our service, visit our page: write my essay

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.